Sony STR-VA555ES Stereo Receiver User Manual


 
75
Operations using the remote
Switching the COMMAND MODE
You can switch the command mode (AV
SYSTEM1 or AV SYSTEM2) of the remote. If
the command mode of the receiver and the
remote is different, you cannot use the remote
to operate the receiver.
1 Press SET UP.
The set up list appears.
AUTO POWER
BACK LIGHT
CONTRAST
pCOMMAND MODE
2 Move the easy scroll key to select
COMMAND MODE, then press the key
to enter the selection.
The COMMAND MODE list appears.
<COMMAND MODE>
pAV SYSTEM1
AV SYSTEM2
3RD ROOM
3 Move the easy scroll key to select AV
SYSTEM1 or AV SYSTEM2, then
press the key to enter the selection.
Tip
When the remote is turned on, the COMMAND
MODE appears in the first line of the display.
Note
3RD ROOM is not available for this receiver.
Clearing all the contents of remotes
memory
Be sure to turn on the receiver and point
the remote towards the receiver when
performing the following procedure.
1 Press SET UP.
The set up list appears.
BACK LIGHT
CONTRAST
COMMAND MODE
pALL CLEAR
2 Move the easy scroll key to select ALL
CLEAR, then press the key to enter
the selection.
The ALL CLEAR list appears.
<ALL CLEAR?>
Yes
pNo
3 Move the easy scroll key to select
Yes, then press the key to enter the
selection.
CLEAR OK?! appears.
<CLEAR OK?!>
Yes
pNo
4 Move the easy scroll key to select
Yes again, then press the key.
All the contents of the remotes memory (i.e.,
all the programmed data) are cleared.