Filter
Top Products
50
Adjustments using the
SET UP button
The SET UP button allows you to make the
following adjustments.
1 Press SET UP.
2 Press the cursor buttons ( or ) to
select the parameter you want to
adjust.
3 Turn the jog dial to select the setting
you want.
The setting is entered automatically.
4 Repeat steps 2 and 3 until you have set
all of the parameters that follow.
Initial settings
Parameter Initial setting
6.1CH DECODING AUTO
MULTI CH 1 or 2 NONE
D.POWER AUTO OFF
V.POWER AUTO OFF
S.FIELD LINK ON
DECODE FORMAT AUTO
AUTO FUNCTION ON
2 WAY REMOTE ON
COMMAND MODE AV1
T.TONE NORMAL
COLOR SYSTEM PAL
OSD COLOR
OSD H.POSITION 4
OSD V.POSITION 4
x 6.1ch decoding mode (6.1CH
DECODING)
You can set this parameter using 6.1CH
DECODING on the front panel (page 33).
• When set to “AUTO”, the receiver performs
6.1 channel decoding only if 6.1 channel signals
decode flag is ON.
• When set to “ON”, the receiver performs
6.1 channel decoding only if the surround
signals are multi channel format [3/2], [3/2+1]
or [3/3] regardless of the 6.1 channel decode
flag.
• When set to “OFF”, the receiver does not
perform 6.1 channel decoding.
Tip
The 6.1 channel decoding flag is the information
recorded on the software (DVD, etc).
x Multi channel assignment
(MULTI CH 1 or 2)
Lets you assign a function to MULTI CH 1 or
2. You cannot assign TUNER or PHONO.
You cannot assign the same function to both
MULTI CH 1 and 2.