Sony CDP-D12 Stereo System User Manual


 
3
For the customers in the U.S.A.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and
receiver.
— Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician
for help.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority
to operate this equipment.
The shielded interface cable recommended in this manual
must be used with this equipment in order to comply with the
limits for a digital device pursuant to Subpart B of Part 15 of
FCC Rules.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
For the customers in the U.S.A. and Canada
Caution
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
This label is located on the top
exterior.
Laser diode properties
Wavelength: 780 nm
Emission duration: Continuous
Laser output power: 30 mW (max.)
For the customers in Canada
This Class B digital apparatus complies with Canadian ICES-
003.
For the customers in Europe
This product with the CE marking complies with both the
EMC Directive (89/336/EEC) and the Low Voltage Directive
(73/23/EEC) issued by the Commission of the European
Community.
Compliance with these directives implies conformity to the
following European standards:
EN60065: Product Safety
EN55103-1: Electromagnetic Interference (Emission)
EN55103-2: Electromagnetic Susceptibility (Immunity)
This product is intended for use in the following
Electromagnetic Environment(s):
E1 (residential), E2 (commercial and light industrial), E3
(urban outdoors), and E4 (controlled EMC environment, ex.
TV studio).
Caution
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
The CDP-D12 is classified as a
CLASS 1 LASER PRODUCT.
The CLASS 1 LASER
PRODUCT label is located on
the top exterior.
CAUTION — CLASS 1M INVISIBLE LASER RADIATION
WHEN OPEN.
DO NOT VIEW DIRECTLY WITH OPTICAL
INSTRUMENTS.
Laser diode properties
Class 1M
IEC60825-1:1993+A1:1997+A2:2001
EN60825-1:1994+A11:1996+A2:2001
Wavelength: 780 nm
Emission duration: Continuous
Laser output power: 30 mW (max.)
CDP-D12 er klassifisert som
LASERPRODUKT KLASSE 1.
Klassemerkingen for KLASSE
1 er plassert utvendig på
oversiden.
ADVARSEL — USYNLIG LASERSTRÅLING KLASSE 1M
HVIS ÅPEN. IKKE SE DIREKTE MED OPTISKE
INSTRUMENTER.
Spesifikasjoner laserdiode
Klasse 1M
IEC60825-1:1993+A1:1997+A2:2001
EN60825-1:1994+A11:1996+A2:2001
Bølgelengde: 780 nm
Strålingens varighet: Kontinuerlig
Laserens effekt: 30 mW (maks.)