Filter
Top Products
22
Recording from a tape
— High-speed Dubbing
You can use TYPE I (normal) or TYPE II (CrO2)
tapes. The recording level is automatically
adjusted.
x
1 Press A A and A B and insert a
recorded tape in deck A and a
recordable tape in deck B.
?/1
(Power)
Multi stick
PUSH ENTER
1
2
3
7
Insert with the side you want to
play/recored facing forward.
2 Press HI-DUB.
Deck B stands by for recording.
3 Press MODE SELECT repeatedly to
select “Set Up Mode”, then press PUSH
ENTER.
4 Move the multi stick toward b or B
repeatedly to select “TAPE Set Up ?”,
then press PUSH ENTER.
5 Move the multi stick toward b or B
repeatedly to select “Direction Set
Up ?”, then press PUSH ENTER.
6 Move the multi stick toward b or B
repeatedly to select “1 Way” to record
on one side, or “Cycle” (or “Relay”) to
record on both sides, then press PUSH
ENTER.
7 Press REC PAUSE/START.
Dubbing starts.
To stop dubbing
Press x.
To cancel the menu operation
Press MODE SELECT.
Tips
• When you dub on both sides, start recording from
the front side. If you record from the reverse side,
recording stops at the end of the reverse side.
• If you select “Cycle” in the “Direction Set Up ?”
menu when the tapes you use have different lengths,
the tape in each deck reverses independently. If you
select “Relay”, the tapes in both decks reverse
together.
• You don’t have to set DOLBY NR, since the tape in
deck B is automatically recorded in the same state
as the tape in deck A.