Filter
Top Products
Chapter 9 Function Menu
Chapter 9 Function Menu 9-3
9-2 Function Menu Item List
The function menu has the following items.
HOME page
a) When an editing operation is carried out, CONFI
playback is disabled.
b) The selection of LTC or VITC depends on the setting of
F6 (TCR) in function menu page 1 .
c) Not displayed when F1 (TCG) is set to INT and F2 (PR/
RGN) is set to PRESET on function menu page 1.
Item
Setting
F1 (VID.IN) Selects the input video signal.
SDI: HDSDI signal
SDTI: SDTI signal (only when option is installed)
SG (normally not displayed): Test signal from the internal test signal generator
(For details, see setup
menu item 710 on page 10-23.)
F2 (PB/EE) Selects the video and audio signals output during fast forward, rewind, stop, and standby.
PB: Playback signals
EE: E-E mode signals
F3 (CONFI) Selects whether or not to use the CONFI playback function when recording.
a)
ENABLE: Use the CONFI playback function.
DISABL: Do not use the CONFI playback function.
F4 (CTL/TC) Selects the time data to display in time data display area 1
(see page 2-7)
.
TC: Playback time code read by the internal time code reader, or recording time code. The LTC or VITC
time data type indicator
(see page 2-7)
lights.
b)
UB: User bits data of playback time code or recording time code. The LUB or VIUB time data type indicator
lights, depending on whether the time code is LTC or VITC.
b)
CTL: The running time of the tape being played back or recorded, as calculated from a count of CTL
signals recorded on the tape. The time is displayed in Hours:Minutes:Seconds:Frames format.
F5 (MENU) Puts the system into setup menu mode (see Chapter 10).
When the current setup menu settings are the same as the contents of any of menu banks 1 to 3, or the
factory defaults, the corresponding indication (1), (2), (3), (4) or (dflt) appears.
(1): Same as menu bank 1.
(2): Same as menu bank 2.
(3): Same as menu bank 3.
(4): Same as menu bank 4.
(dflt): Same as factory defaults.
F6 (TCGSET) • When F4 (CTL/TC) is set to TC, a screen appears that allows you to set the initial value of the time code
generated by the internal time code generator
(see page 4-3)
.
c)
• When F4 (CTL/TC) is set to UB, a screen appears that allows you to set the time code user bits
(see
page 4-3)
.
c)