Filter
Top Products
Chapter 10
Setup Menus
Chapter 10
Setup Menus 10-21
Item number Item name
Settings
620 TC CONVERT 24F t
25F (in 50i or 25PsF mode
only)
Select whether to convert playback time code to 25F time code during playback
of tape recorded in 24PsF or 23.98PsF mode.
OFF : Do not convert time code.
ON: Convert time code.
TC CONVERT 25F t
24F (in 24PsF or
23.98PsF mode only)
Select whether to convert playback time code to 24F time code during playback
of tape recorded in 50i or 25PsF mode.
OFF : Do not convert time code.
ON: Convert time code.
621 24F STARTING TC SEL
(in 50i or 25PsF mode
only)
Select one of the following setting for time code conversion from 24F to 25F.
OFF : Do not set the starting TC
ON: Set the starting TC
To set the 24F starting TC
Press the F5 (SET) button with this menu item displayed in the menu display, to
enter the starting TC setting mode. You can then set the user starting TC digit by
digit using the F1 (PREV) button and F2 (NEXT) buttons for digit selection. When
all required digits have been set correctly, press the F5 (SET) button again to
save the starting TC and exit from the ID code setting mode.
25F STARTING TC SEL
(in 24PsF or 23.98PsF
mode only)
Select one of the following setting for time code conversion from 25F to 24F.
OFF : Do not set the starting TC
ON: Set the starting TC
To set the 25F starting TC
Press the F5 (SET) button with this menu item displayed in the menu display, to
enter the starting TC setting mode. You can then set the user starting TC digit by
digit using the F1 (PREV) button and F2 (NEXT) buttons for digit selection. When
all required digits have been set correctly, press the F5 (SET) button again to
save the starting TC and exit from the ID code setting mode.
622 24F JUMPING TC SEL (in
50i or 25PsF mode only)
Select one of the following setting for time code conversion from 24F to 25F.
–3H : Set JUMPING TC to “STARTING TC –3H”.
–2H : Set JUMPING TC to “(STARTING TC –2H”.
–1H : Set JUMPING TC to “(STARTING TC –1H”.
+1H : Set JUMPING TC to “(STARTING TC +1H”.
+2H : Set JUMPING TC to “(STARTING TC +2H”.
+3H : Set JUMPING TC to “(STARTING TC +3H”.
0H : Set JUMPING TC to STARTING TC”.
25F JUMPING TC SEL (in
24PsF+A23.98PsF mode
only)
Select one of the following setting for time code conversion from 25F to 24F.
–3H : Set JUMPING TC to “STARTING TC –3H”.
–2H : Set JUMPING TC to “(STARTING TC –2H”.
–1H : Set JUMPING TC to “(STARTING TC –1H”.
+1H : Set JUMPING TC to “(STARTING TC +1H”.
+2H : Set JUMPING TC to “(STARTING TC +2H”.
+3H : Set JUMPING TC to “(STARTING TC +3H”.
0H : Set JUMPING TC to STARTING TC”.
651 UMID OUTPUT Select UMID output and the UMID type.
off : Do not output UMID.
BASIC: Output Basic UMID.
EXTENDED: Output Extended UMID.
Note
Evin if EXTENDED is selected, Basic UMID is output if Basic UMID is recorded
on the tape being played back.
Menu items in the range 600 to 699, relating to the time code generator (Continued)