Filter
Top Products
27
HCD-C5
5-1. Operating the Continuous Playback Mode
1. Entering the continuous playback mode
(1) Set the disc in the unit. (Whichever recordable discs or discs
for playback only are available)
(2) Press the . “R” or > “R” button to display
“CPLAY1MODE” (C34).
(3) Press the ENTER/YES “R” button to change the display
to “CPLAY1MID”.
(4) When access completes, the display changes to “C =
AD = )”.
Note: The numbers “ ” displayed show you error rates and ADER.
2. Changing the parts to be played back
(1) Press the ENTER/YES “R” button during continuous play-
back to change the display as below.
When pressed another time, the parts to be played back can
be moved.
(2) When access completes, the display changes to “C =
AD = )”.
Note: The numbers “ ” displayed show you error rates and ADER.
3. Ending the continuous playback mode
(1) Press the MENU/NO “R” button. The display will change
to “CPLAY1MODE” (C34).
(2) Press the MD Z button and take out the disc.
Note: The playback start addresses for IN, MID, and OUT
are as follows.
IN : 40h cluster
MID : 300h cluster
OUT : 700h cluster
“CPLAY1MID” t “CPLAY1OUT” t “CPLAY1IN”
5-2. Operating the Continuous Recording Mode (Use
only when performing self-recording/palyback
check)
1. Entering the continuous recording mode
(1) Set a recordable disc in the unit.
(2) Press the . “R” or > “R” button to display “CREC
1MODE” (C35).
(3) Press the ENTER/YES “R” button to change the display to
“CREC 1MID”.
(4) When access completes, the display changes to “CREC 1(
)” and “ REC ” is displayed.
Note: The numbers “ ” displayed shows you the recording posi-
tion addresses.
2. Changing the parts to be recorded
(1) When the ENTER/YES “R” button is pressed during con-
tinuous recording, the display changes as below.
When pressed another time, the parts to be recorded can be
changed. “ REC ” goes off.
(2) When access completes, the display changes to “CREC 1(
)” and “ REC ” is displayed.
Note: The numbers “ ” displayed shows you the recording posi-
tion addresses.
3. Ending the continuous recording mode
(1) Press the MENU/NO “R” button. The display changes to
“CREC 1MODE” (C35) and “ REC ” goes off.
(2) Press the MD Z button and take out the disc.
Note 1: The recording start addresses for IN, MID, and OUT are
as follows.
IN : 40h cluster
MID : 300h cluster
OUT : 700h cluster
Note 2: The MENU/NO “R” button can be used to stop recording
anytime.
Note 3: Do not perform continuous recording for long periods of
time above 5 minutes.
Note 4: During continuous recording, be careful not to apply vi-
bration.
“CREC 1MID” t “CREC 1OUT” t “CREC 1IN”
REC
REC
REC
REC