Filter
Top Products
17
HCD-C5
3-11. BASE SECTION
5
two screws
(+P2 x 5)
4
Remove solderings from
the damper pins.
2
Remove the two damper
pins toward inside.
3
Slant the base block in the
direction of the arrow
B
and remove the base
block from the main unit in
a manner that the lock pin
passes through the groove
of the holder (L) as shown.
2
base section
(
2
Remove the base block while the
mechanism is in the Loading IN state.)
lock pin
holder (L)
1
pick-up flexible
board
2
Remove the two hang-up
springs (FZ) as shown.
1
Move the holder (L) in the
direction of the arrow
A
.
A
B
3
Remove the two hang-up
springs (R) as shown.
1
Remove solderings.