Filter
Top Products
7
2 Press TUNER repeatedly until the
band you want appears.
Each time you press the button, the band
changes as follows:
North American model:
FM n AM
European model:
FM n MW n LW
Other models:
FM n MW n SW
3 Press AUTO.
4 Turn MULTI JOG.
The frequency indication changes and
scanning stops when the system tunes in
a station. “TUNED” and “STEREO” (for
a stereo program) appear. To stop
tuning, press p.
Presetting the radio
station
5 Press EDIT/NO, then turn MULTI
JOG until “TUNER Memory ?”
appears.
6 Press ENTER/YES.
7 Turn MULTI JOG to select the
desired preset number.
8 Press ENTER/YES.
The station is stored.
9 Repeat steps 2 through 8 to preset
other stations.
To tune in a station with a weak
signal
Press MANUAL in step 3, then turn MULTI
JOG to tune in the station and continue from
step 5.
To change the preset number
Start over from step 2.
To change the AM/MW tuning
interval (except for European
model)
The AM/MW tuning interval is factory-set to
9 kHz (10 kHz in some areas). To change the
AM/MW tuning interval, tune in any AM/
MW station first, then turn off the power.
While holding down the DIMMER button,
turn the power back on. When you change
the interval, all the AM/MW preset stations
are erased. To reset the interval, repeat the
same procedure.
Tips
•The preset stations are retained for about a day if
you disconnect the AC power cord or if a power
failure occurs.
•You can label the preset stations (see page 55).
TUNED STEREO
AUTO
Me or ym?FM 1CH
TUNED STEREO
AUTO
TU Me or ymNER ?
nn
n