Filter
Top Products
43
4 Press ENTER/YES.
“LEVELSync ON?” appears.
5 Press ENTER/YES again.
“LEVEL-SYNC” lights up.
6 Press (P.
Recording starts.
To stop recording
Press p.
To cancel the track marking
1 In recording pause mode, press EDIT/NO,
then turn MULTI JOG until “LevelSync ?”
appears.
2 Press ENTER/YES.
“LevelSyncOFF?” appears.
3 Press ENTER/YES again.
“LEVEL-SYNC” goes off.
While “LEVEL-SYNC” is not lit, a track
number is marked only at the beginning of
each recording.
Note
You cannot mark track numbers automatically if the
sound source to be recorded is noisy (e.g., tapes or
radio programs).
Marking track numbers at
a specific point while
recording
You can mark track numbers at any time
while recording, regardless of the type of
sound source, or type of connection.
Press REC/CD-MD SYNC while
recording at the point you want to add a
track mark.
The tracks following the added one are
renumbered.
You can mark track numbers using the
following methods:
• Automatically during recording
When you record from this system’s CD (digital
recording), the track numbers are automatically
marked. When recording from other sources, you
can mark track numbers automatically using the
Level Synchro Recording function.
• At any point while recording
You can mark track numbers while recording
from any sources.
Marking track numbers
automatically while
recording
— Level Synchro Recording
Track numbers are automatically marked
when the input signal continues to be under a
certain level for more than two seconds and
then exceeds the previous level.
This function is factory set to on. If “LEVEL-
SYNC” does not appear in the display during
analog recording, set it to on following the
procedure below.
Marking track
numbers
1 Press FUNCTION repeatedly to
select “TUNER,” “TAPE” or
“VIDEO/GAME.”
2 Press REC/CD-MD SYNC.
The MD deck stands by for recording.
3 Press EDIT/NO, then turn MULTI
JOG until “LEVELSync ?” appears.
TAPE
REC/CD-MD SYNC
2
4,5
3
6
p
1
TAPE