Filter
Top Products
66
Troubleshooting (continued)
A code made up of three letters and
message flash alternately.
•The Self-Diagnostic function is working.
Solve the problem referring to the check
list (page 65).
Speakers
Sound comes from one channel or the left
and right volume are unbalanced.
•Check the speaker connections and
speaker placement.
CD Player
The CD tray does not close.
•The CD is not placed properly.
The CD will not eject.
•The CD has tape, seals, or paste on it.
The CD will not play.
•The CD is dirty.
•The CD is inserted label side down.
•Moisture condensation has built up.
Remove the CD and leave the system
turned on for about an hour until the
moisture evaporates.
Play does not start from the first track.
•The player is in program or shuffle mode.
Press CONTINUE.
“OVER” is displayed.
•You have reached the end of the CD.
Press 0 or turn MULTI JOG to return to
the beginning of the CD.
The CD indicator lights up when no CDs
are inserted in the disc tray.
•The CD indicator lights up when you
turn on the system for the first time. It
will go off after a while.
•Last time you used the system, you
turned it off with the disc tray opened. It
will go off after a while. If not, press
CD 6 several times to open and close the
disc tray.
MD Deck
An partially inserted MD cannot be pulled
out.
•The MD deck’s self-lock system has
gripped the MD. Insert the MD
completely, then press MD 6.
An MD cannot be inserted.
•Insert the MD with the label side up in
the direction of the arrow.
The controls do not work.
•The MD is dirty or scratched. (“Disc
Error” appears.) Replace the MD with a
new one.
The MD will not play.
•Moisture condensation has built up.
Remove the MD and leave the system
turned on for several hours until the
moisture evaporates.
•Insert the MD in the direction of the
arrow.
•Nothing is recorded on the MD.
Recording is not possible.
•The MD is protected against erasure.
(“MD Protected” appears.) Slide the tab
to close the slot (see page 33).
•Connect the sound source properly.
•A pre-recorded MD is in the deck.
Replace the disc with a recordable MD.
•Replace the disc with a recordable MD
that has sufficient time remaining or erase
unnecessary tracks.
•The AC power cord was unplugged or a
power interruption occurred during
recording. Start recording over from the
beginning.
Recording cannot be made on all MDs
during CD-MD Synchro Recording
•Either CD or MD is not inserted in the
same disc number.
“OVER” is displayed.
•You have reached the end of the MD.
Press 0 or turn MULTI JOG to return to
the beginning of the MD.