Filter
Top Products
62
To check the timer
Follow the procedure in “To turn on or off the
timer” (see page 61). Select the timer number
you want to check in step 1 and select “ON”
in step 2. The setting appears at the end of
the procedure.
When the setting time is
overlapped
The time indicated with cannot be
recorded.
Tip
The MD is automatically labeled with the Station
Name (or frequency if the station is not labeled), the
start time and the stop time of the recording (see
page 55).
REC 1
REC 2
REC 1
REC 2
REC 1
REC 2
The last 30 seconds
The last 30 seconds
Timer recording radio programs
(continued)
Notes
•If you select “MDALL” in step 9 to record a long
program and the MD in the MD 1 slot becomes
full, the rest of the program is automatically
recorded on the MD in the next slot. If no other
MDs are inserted, insert another recordable MD in
the next slot and remove the MD you do not want
to record on beforehand. The program will not be
recorded while the MDs are being exchanged.
•Do not operate the system from the time the
power turns on until the recording starts (about 30
seconds).
•If the start time and stop time are the same, the
cursor goes back to the stop time. Change the stop
time.
•When you record on a blank MD, the first 30
seconds are not recorded.
•If the power is on at 30 seconds before the preset
time, the recording will not be made.
•The volume is reduced to minimum during
recording.