Filter
Top Products
11
US
Chapter 1 Getting Started
Selecting a method for using the remote
Connections between the Unit and each device are made
via cables or cords coming through the wall.
You can operate a component using the remote if the IR
IN/OUT terminal of the Unit and the component are
connected. For example, if you connect IR IN of the Unit
and IR OUT of a TV, you can operate the Unit with the
Remote by aiming it at the TV.
1 Press the “V” SELECT on the HOME Menu, then
press the “SETUP” SELECT.
The Setup Menu appears.
2 Press the “V” SELECT repeatedly until “IR ROUTE”
appears on the front panel display.
3 Press the “IR ROUTE” SELECT.
The IR route setup Menu appears.
4 Select a method for using the remote.
The default setting is underlined.
Method Operates
EYE The Unit directly from the remote.
JACK The Unit through the IR IN jack using signals
from the remote.
Both The Unit directly and through the IR IN
jack using signals from the remote.
Continue to the next page
l
Contact your nearest installer for details on the default
setting for each parameters.
For details on how to make a selection in the Menu, see
page 18.
Setting an IP Address
There are two ways to acquire an IP address.
The default setting is underlined.
•
AUTO: You can acquire the IP address
automatically.
Normally, select this setting.
• MANUAL: You can set up the IP address manually.
Because some knowledge of networking is
required to use this setting, we recommend
you normally to select “AUTO.”
1 Press the “V” SELECT on the HOME Menu, then
press the “SETUP” SELECT.
The Setup Menu appears.
2 Press the “V” SELECT repeatedly until “LAN”
appears on the front panel display.
3 Press the “LAN” SELECT.
The LAN setup Menu appears.
4 Press the “IP ADDRESS” SELECT.
The IP address setup Menu appears.
Setting up the Units