Filter
Top Products
16
8 REMOTE CONTROL
Insert the batteries, taking care to match the polarity, as indi-
cated in the battery recess of the remote (Fig. 24).
+
-
+
-
+
-
+
-
Fig. 24
Change the batteries in the remote control if experiencing
difficulty in sending commands to the projector.
If the remote control is not to be used for a long period of
time remove the batteries. Replace all batteries at the same
time; do not replace one new battery with a used battery. If
the batteries have leaked, carefully wipe the case clean and
replace with new batteries.
The remote control sends commands to the projector via
infrared signals.
It is possible to control the projector by pointing the remote
control at the screen; the sensor at the front of the projector will
pick up the reflected infrared commands. (Fig. 25).
C-SYNC
DVI
F1
ZOOM
LIGHT
Fig. 25
Avoid placing obstructions between the remote control and
the infrared sensor at the front of the projector; this will impair
the remote control performance.
four 1,5 V
AAA type
batteries