Sharp SD-AS10 Stereo System User Manual


 
38
SD-AS10
Radio Operation
- Listening to the radio -
Listening to the radio
You can also use the TUNER (BAND), TUNING DOWN or TUNING UP button on the
main unit.
To receive an FM stereo transmission:
Press the TUNER (BAND) button to display the "ST" indicator.
! " " will appear when an FM broadcast is in stereo.
! If the FM reception is weak, press the TUNER (BAND) button to turn off the "ST"
indicator. The reception changes to mono, and the sound becomes clearer.
After use:
Press the POWER button to enter the power stand-by mode.
1 Turn on the power and press the TUNER (BAND) button to set the
input to "FM (AM)".
2 Press the TUNER (BAND) button repeatedly to select the desired
frequency band.
3 Press the TUNING ( or ) button to tune in to the desired station.
Manual tuning:
Press the TUNING button as many times as required to tune in to the desired
station.
Auto tuning:
When the TUNING button is pressed for 0.5 seconds or more, scanning will start
automatically and the tuner will stop at the first receivable broadcast station.
! When radio interference occurs, auto scan tuning may stop automatically.
Should this happen, tune in manually.
! Auto scan tuning will skip weak signal stations.
! To stop the auto tuning, press the TUNING button again.
FM stereo mode indicator
FM stereo receiving indicator
FM stereo FM mono AM