Filter
Top Products
Synchronizing transmitters with receivers
44
Synchronizing transmitters with
receivers
When synchronizing a transmitter with a receiver, please observe the
following:
Synchronizing a transmitter with the receiver –
individual operation
Upon delivery, transmitter and receiver are synchronized with each other.
If, however, you cannot establish a transmission link between transmitter
and receiver, you have to synchronize the channels of the devices:
̈ With the receiver, perform a frequency preset scan to scan the
frequency banks for unused channels (“Scan New List”, see page 34).
Then “Sync” appears on the display panel of the receiver.
̈
Synchronize a transmitter with the receiver via the infra-red interface
(see page 22).
This establishes a transmission link between the transmitter and the
receiver.
Alternatively, you can set the channel on the transmitter manually:
̈ Make sure that you set the transmitter to the same frequency bank and
the same channel as the receiver (see the instruction manual of the
transmitter).
̈ Only use a transmitter and a receiver from the same frequency
range (see the type plate on the transmitter and the receiver).
̈ Make sure that the desired frequencies are listed in the enclosed
frequency information sheet.
̈ Make sure that the desired frequencies are approved and legal
in your country and, if necessary, apply for an operating license.
531.375 MHz
B.Ch: 20.24
Sync
Easy Setup
PEAK
-10
040
30
20
10
-20
-40
AF
RF
-30
ew300 G3