Filter
Top Products
Adjustment tips and functions
31
Adjustment tips and functions
The operating menu allows you to make settings for your receiver and your
transmitters. The “Soundcheck” standard display provides an additional
function and can be called up by turning the jog dial, without having to get
into the operating menu.
Doing a soundcheck
By doing a soundcheck, you can check the reception area for field strength
gaps (“dropouts”) which cannot be compensated for by the receiver’s
diversity circuitry.
̈ If necessary, change from the “Soundcheck” standard display to one of
the other standard displays of your receiver.
̈ Position the transmitter in the area in which it is to be used and switch
it on.
̈ Leave the transmitter switched on and go to your receiver.
̈ On the receiver, change to the “Soundcheck” standard display.
̈ Go to your transmitter.
The “Soundcheck” standard display must not be activated until
later because otherwise the recording will give wrong results.
If no transmitter is being received or if the signal is below the
squelch threshold level, “MUTE” appears on the display panel
(see
“If a problem occurs ...” on page 50).
Soundcheck
20.24 ew300 G3
531.375
MHz
531.375
SKM300
ew300 G3
B.CH: 20.24
EQ
+ 12dB
MHz
P
P
PEAK
-10
040
30
20
10
-20
-40
AF
RF
-30
PEAK
-10
0
40
30
20
10
-20
-40
AF
RF
-30
“Soundcheck”
standard display
Select any other
standard display
Soundcheck
20.24 ew300 G3
531.375
MHz
531.375
SKM300
ew300 G3
B.CH: 20.24
EQ:
+ 12dB
MHz
P
P
PEAK
-10
040
30
20
10
-20
-40
AF
RF
-30
PEAK
-10
0
40
30
20
10
-20
-40
AF
RF
-30
“Soundcheck”
standard display
“Receiver Parameters”
standard display