Filter
Top Products
Putting the receiver into operation
14
Mounting the receiver into a 19” rack
Rack mounting
one receiver
̈ Secure the rack mount “ears” ƿ of the supplied GA 3 rack adapter to
the receiver as described on page 12.
̈ Secure the blanking plate of the supplied GA 3 rack adapter to one
of the rack mount “ears” ƿ using two recessed head screws (M 6x10).
Do not fit the device feet when mounting the receiver into a
19” rack.
CAUTION! Risks when rack mounting the receiver!
When installing the device in a closed or multi-rack assembly, please
consider that, during operation, the ambient temperature, the mechanical
loading and the electrical potentials will be different from those of devices
which are not mounted into a rack.
̈ Make sure that the ambient temperature within the rack does not
exceed the permissible temperature limit specified in the specifications
(see page 54).
̈ Ensure sufficient ventilation; if necessary, provide additional ventila-
tion.
̈ Make sure that the mechanical loading of the rack is even.
̈ When connecting to the power supply, observe the information indi-
cated on the type plate. Avoid circuit overloading. If necessary, provide
overcurrent protection.
̈ When rack mounting, please note that intrinsically harmless leakage
currents of the individual mains units may accumulate, thereby
exceeding the allowable limit value. As a remedy, ground the rack via an
additional ground connection.