Filter
Top Products
Adjustment tips and functions
39
Setting a frequency
bank and a channel
and assigning this
channel a receiving
frequency
̈ Set the desired frequency bank.
̈ Set the desired channel.
̈ Set the desired frequency.
“Sync Settings”
Via the “SK Settings” and “SKM Settings” menu items, you can set the
transmitter parameters directly on the receiver and activate or deactivate
the transfer of these parameters to the transmitter:
By pressing the button », you can transfer the parameters to the
transmitters via the infra-red interface (see page 22).
̈ Turn the jog dial until the “Tune” menu item appears.
̈ Press the jog dial and keep it pressed until the frequency bank
selection appears.
̈ Press the jog dial.
The channel selection appears.
̈ Press the jog dial.
The frequency selection appears.
̈ Press the jog dial.
Your settings are stored.
You are back to the operating menu.
Set the frequency
bank and the channel
Tune
531.740 MHz
Set the frequency
bank and the channel
Tune
Call up “Tune”
(special function)
Advanced Menu
531.740 MHz
Exit
Tune
Sync Settings
“Stored”
B.Ch: U1. 1 B.Ch: U1. 1
531.740 MHz
PEAK
-10
040
30
20
10
-20
-40
AF
RF
-30
PEAK
-10
040
30
20
10
-20
-40
AF
RF
-30
PEAK
-10
040
30
20
10
-20
-40
AF
RF
-30
Tune
Sync Settings
Pilot Tone
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
Advanced Menu
Setting Transfer is ...
... activated
... deactivated
Sensitivity
-69 dB
Sync
PEAK
-10
040
30
20
10
-20
-40
AF
RF
-30
Sensitivity
-69 dB
Sync
PEAK
-10
040
30
20
10
-20
-40
AF
RF
-30