Filter
Top Products
Overview of Controls
OPEN/CLOSE Press to open or close the disc tray.
ON/STANDBY Press to turn on your unit, or put your unit in standby
mode. When your unit is in standby mode, power is
still entering your unit. To disconnect power, unplug
the power cord.
Numbers In playback mode, press GOTO button, then press
the number buttons to enter a title, chapter, track,
or time.
CLEAR Press to clear an input.
GOTO Press to search for a title, chapter, track or time.
A(red),
B(green),
C(yellow),
D(blue)
When playing a Blu-ray Disc that has a Java
application, press to control playback. For more
information, see the documentation that came with
the Blu-ray Disc.
VOL+/- Press to increase or decrease the volume.
MUTE Press to turn o sound. Press again to turn the
sound back on.
POP UP During Blu-ray Disc playback, press to open a menu
that lets you control Blu-ray Disc playback.
During DVD playback, press to open the DVD title
menu (if available).
SKIP
/ Press to go to the next or previous chapter (Blu-ray
Disc/DVD) or track (CD).
In tuner mode, press to go to the next higher /lower
preset station.
REV Press to fast reverse.
STOP Press to stop playback.
PLAY/PAUSE Press to start or pause playback.
FWD Press to fast forward.
, /TUNE ,
/TUNE ,
Navigate through the menus. The left and right arrows also
tune the radio frequency in the tuner mode.
OK Con rms your selection.
EXIT Press to return to the previous menu.
SETUP Press to access the speaker setting and test tone.
To enable or disable the Center speaker/surround speakers,
press this button, and press
/ buttons to select Center
Speaker or Surround Speaker, then use
/ buttons on
the remote control to choose YES or NO.
To start or end the test tone, press this button, and
press
/ buttons to select TS TONE, then press OK
button. The audio signal will be sent to a di erent
speaker every approximately two seconds; you can
also use
/ buttons to select the speaker channel
you wish to test and adjust, you’ll hear a test tone
coming from the speaker you select, use
/
buttons to adjust the level to your desired setting.
Press OK button to exit this function.
OPTICAL Press to select OPTICAL input source.
AUX Press to select AUX input source.
TUNER Press to select TUNER mode, and toggle between
the FM and AM bands.
-12-
English IB(A5).indd 14English IB(A5).indd 14 4/15/2010 20:19:114/15/2010 20:19:11