Polycom C8 Speaker System User Manual


 
Installing SoundStructure Devices
7 - 7
If the device is running a configuration file that had previously been uploaded,
the output channels will be muted while the new configuration is uploaded.
The audio will be unmuted after the upload of the configuration file has been
completed.
Once the file has been uploaded, the settings are stored in the non-volatile
memory of the device.
Downloading A Configuration File
As with uploading a configuration file, downloading a configuration file from
a SoundStructure device to SoundStructure Studio involves selecting the Con-
nect to Devices menu option, selecting the interface to connect to (ethernet or
serial), selecting the device from the list of devices found and finally selecting
“Get configuration from devices” and then clicking the Connect button. The
settings from the device will be retrieved and displayed within SoundStruc-
ture Studio.
Updating Firmware
Once connected to a SoundStructure device, the SoundStructure firmware
may be updated using SoundStructure Studio. As the firmware files are nearly
ten megabytes in size, it is recommended that SoundStructure Studio connect
to the SoundStructure device over its Ethernet interface to minimize the firm-
ware file transfer time.
If updating firmware over RS-232, it is recommended that the 115,200 baud
rate be selected on the SoundStructure device. At 115,200 baud, a typical firm-
ware file transfer will require approximately ten minutes. When the Ethernet
interface is used, the file transfer time will be reduced to seconds.