Filter
Top Products
Controlling the rest of your system
11
74
En
5 Use
/
to select a command in the sequence then
press
ENTER
.
If this is the first command in the sequence, select
1ST
CODE
. Otherwise, simply choose the next command in
the sequence.
PRES KEY
flashes after you press
ENTER
.
6 If necessary, press the input source button for the
component whose command you want to input.
This is only necessary if the command is for a new
component (input source).
7 Select the button for the command you want to
input.
The following remote control commands can be
selected:
• You don't need to program the receiver to switch on
or off. This is done automatically.
With Pioneer components
, you don’t need to:
• program the power to switch off in a shutdown
sequence (except DVD recorders);
• program the power to switch on if it’s the source
component selected in step 3;
• program a Pioneer TV or monitor to switch on if the
input function (selected in step 2) has video input
terminals;
These take priority in multi operations (not shutdown).
8 Repeat steps 5–7 to program a sequence of up to
five commands.
9 When you’re finished, use
/
to select EDITEXIT
from the menu and press
ENTER
.
You will return to the remote control
SETUP
menu. Select
* EXIT *
again to exit.
Using multi operations
You can start multi operations with the receiver switched
on, or in standby.
1 Press MULTI OPE.
MULTI OP
flashes in the display.
2
Press
an input source button that has been set up
with a multi operation.
The receiver switches on (if it was in standby) and the
programmed multi operation is performed automatically.
Using System off
1 Press MULTI OPE.
MULTI OP
flashes in the display.
2 Press
SOURCE
.
The command sequence you programmed will run, then
all Pioneer components will switch off
1
, followed by this
receiver.
SLEEP
+
10
SR
+
ANALOG
ATT
DISC
VIDEO
SEL
DIMMER
S.RETRIEVER
CLASS
D.ACCESS
RECEIVER SOURCE
SYSTEM OFF
INPUT
SELECT
ENTER
TV CONTROL
DVD SAT
VIDEO 1 TV CONT
DVR1
TUNE
TUNE
ST ST
i Pod
TUNER
RECEIVER
ENTER
AV PARAMETER
TOP MENU ì
DTV MENU
CH LEVEL
MENU
T.EDIT
BAND
GUIDE
RETURN
SETUP
CATEGORY
CD
DVR2
CD-R
TV VIDEO 2
XM RADIO
ROOM2/3
ì
TV CONTROL
VOL
STATUS
SIGNAL SEL
PHOTO
SBch
STEREO
MEMORY
TV CH
INPUT
SELECT
MPX
AUDIO SUBTITLE
DTV INFO
MUTE
REC
TV VOL
REC STOP
HDD
CH
CH
DVD
DISP
Note
1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes are sent.
DIMMER
SHIFT
STATUS
MCACC S.DIRECT
MULTI OPE
SIGNAL SEL
PHOTO
SBch
STEREO
ADV. SURR
STANDARD
PHASE
THX
RECEIVER
DIMMER
RECEIVER SOURCE
SYSTEM OFF
INPUT
SELECT
DVD SAT
VIDEO 1 T V CONT
CD TV VIDEO 2
DIMMER
SHIFT
STATUS
MCACC S.DIRECT
MULTI OPE
SIGNAL SEL
PHOTO
SBch
STEREO
ADV. SURR
STANDARD
PHASE
THX
RECEIVER
VSX_84TXSi.book.fm 74 ページ ２００６年３月１３日 月曜日 午前１１時５４分