Pioneer S-HTD330 Speaker System User Manual


 
Before you start
01
9
En
What’s in the box
Please confirm that the following accessories
are in the main system box when you open it.
Remote control
AA/R6P dry cell batteries (x2)
Video cable (yellow plugs)
AM loop antenna
FM wire antenna
Power cable
These operating instructions
Warranty card
Please confirm that the following accessories
are in the speaker box when you open it.
Speaker cables (x6)
non-skid pads for speakers (1 sheet)
Putting the batteries in the
remote control
1 Open the battery compartment cover
on the back of the remote control.
2 Insert two AA/R6P batteries into the
battery compartment following the
indications (
,
) inside the
compartment.
3 Close the cover.
Incorrect use of batteries can result in
hazards such as leakage and bursting. Please
observe the following:
Don’t mix new and old batteries together.
Don’t use different kinds of battery
together—although they may look similar,
different batteries may have different
voltages.
Make sure that the plus and minus ends
of each battery match the indications in
the battery compartment.
Remove batteries from equipment that
isn’t going to be used for a month or
more.
When disposing of used batteries, please
comply with governmental regulations or
environmental public instruction’s rules
that apply in your country or area.
H048 En
Using the remote control
Keep in mind the following when using the
remote control:
Make sure that there are no obstacles
between the remote and the remote
sensor on the system unit.
The remote has a range of about 23 ft. /
7 m at an angle of less than 30º.
Remote operation may become unreliable
if strong sunlight or fluorescent light is
shining on the system unit’s remote
sensor.
XV-HDT330_new.book 9 ページ 2003年1月16日 木曜日 午後4時12分