Pioneer S-HTD330 Speaker System User Manual


 
Home theater sound
05
38
En
Music
– Pro Logic II 5.1 channel surround
sound, especially suited to music
sources, for use with any two-channel
source (see also
Dolby Pro Logic II Music
settings
below)
Stereo
– See
Listening in stereo
below
See also
Using the Advanced Surround
effects
below, for further stereo and
surround playback options.
You can’t use the Surround modes with
high sampling rate 88.2 / 96 kHz sources.
When listening in
Dolby Digital
/
DTS
mode, two-channel material will
automatically be played in surround
sound using Dolby Pro Logic decoding.
Dolby Digital / DTS sources that use only
the center channel cannot be played back
in surround sound.
Dolby Pro Logic II Music settings
When listening in Dolby Pro Logic II Music
mode, there are three further parameters you
can adjust: Center Width, Dimension, and
Panorama.
1 With Dolby Pro Logic II Music mode
active, press SOUND MODE.
2 Use the
/
(cursor left/right)
buttons to select ‘C Width’, ‘Dimen.’ or
‘Pnrm.’
C Width
(Center Width): Makes the
center channel wider (higher settings) or
narrower (lower settings)
Dimen.
(Dimension): Makes the sound
more distant (minus settings), or more
forward (positive settings)
Pnrm.
(Panorama): Creates more
spacious surround sound
3 Use the
/
(cursor up/down)
buttons to adjust the setting.
Center Width is adjustable between
0
and
7
;
Dimension between
–3
and
+3
. Panorama is
On
or
Off
.
4 Press ENTER to confirm.
Listening in stereo
You can listen to any source—stereo or
multichannel, analog or digital—in stereo.
When playing a multichannel source, stereo
sound is created by downmixing all channels
to the front left/right speakers and the
subwooofer.
Press SURROUND repeatedly until
‘Stereo’ shows in the display.
Any active Advanced Surround mode is
cancelled.
See also
Using the Advanced Surround
effects
below, for further stereo and
surround playback options.
Listening with headphones
When headphones are connected, only the
Stereo
(default) and
Phones Surround
(virtual surround sound for headphones)
modes are available.
When you connect a pair of headphones, the
listening mode automatically changes to
Stereo
. When you disconnect them it reverts
to the previous mode.
SURROUND
XV-HDT330_new.book 38 ページ 2003年1月16日 木曜日 午後4時12分