Filter
Top Products
35
OPERATION
Playing Sources with Stereo Sound
The following instructions show you how to play audio or audio-visual stereo sources with the VSX-D908S.
1
Turn on the power of the playback component.
2
Press the RECEIVER button to turn
on the receiver.
Be sure that the standby indicator turns off
on the front panel.
3
Press MULTI CONTROL buttons or the FUNCTION
button on the remote control or turn the INPUT
SELECTOR dial on the front panel to select the source
you want to playback.
The FUNCTION button cycles through the sources in the following
order:
TUNERMD/TAPE 1
VCR 2 VCR 1
TV/SATDVD/LD
VIDEO
CD
PHONO
4
Press SIGNAL SELECT on the remote control or
SIGNAL SELECT on the front panel to select the input
signal corresponding to the source component.
(See “Switching ANALOG/DIGITAL signal input” on p. 40.)
5
Start playback of the component you selected in step
1.
6
Adjust the volume by using the MASTER VOLUME
buttons on the remote control or the MASTER
VOLUME on the front panel.
If you are not able to get sound from the receiver the problem
may well lie with the SIGNAL SELECT switch. You need to
make sure the input is set to the appropriate ANALOG or
DIGITAL setting. Refer to page 40 for more on this.
S0URCE
DVD/LD TV/SAT
VCR1 VCR2
CD
TV VOL
TV FUNC
MENU
ENTER
STEREO
DIGITAL NR
MIDNIGHT
ADVANCED STANDARD
DSP
MUTE
TV
VOLUME
MD/
TAPE1
TUNER
TV CONT
RECEIVER
MULTI
OPERATION
CLASS MPX
MULTI CONTROL
DIRECT ACCESS
STATION
CHANNEL
TUNING
DTV ON/OFF DTV MENU
EXIT
DISC+10
GUIDE
TV CONTROL
FUNCTION
SIGNAL
SELECT
EFFECT
/CH SEL
2/dts
DIGITAL MULTI PROCESSING AMPLIFIER
REMOTE CONTROL UNIT
REMOTE
SETUP
SYSTEM
SETUP
BAND
SYSTEM
OFF
1
23
4
56
7
89
0
ENTER
Î
¶
73
1¡4¢
+
-
+
-
+
-
8
2
3
6
3
4
2
3
64
STANDBY/ON
DSP
MODE
SIGNAL SELECTADVANCED STANDARD
STANDBY
AUDIO/VIDEO MULTI-CHANNEL RECEIVER
STEREO
/DTS
N∫m¿ /?˘∫
STANDBY
indicator
Basic Playback