Filter
Top Products
30
Surround Sound Set Up
3
After selecting SETTING START with the button
press ENTER. The TEST TONE will be output.
These settings will be displayed on your TV.
[ 0dB]
[ 0dB]
[ 0dB]
[ 0dB]
[ 0dB]
[ 0dB]
Channel Level
Front L
Center
Front
Surround
Surround
Subwoofer
L
R
R
L
Test Tone [ AUTO ]
[Setting OK ]
dB
STEREO
SIGNAL
SELECT
ANALOG
SP
A
AUTO
VOLUME
It takes a moment for the machine to set itself. MASTER VOLUME
rotates to the reference position (0dB), and the test tone is output.
To exit before outputting the TEST TONE
Press ENTER.
To exit while outputting the TEST TONE
Press ENTER.
4
Adjust speaker levels so that you hear the test tone at
the same volume from each speaker when seated in
your main listening position.
NOTE : The volume of the sub-woofer tends to sound lower than it
actually is, you may need to raise its level after testing the sound
with actual soundtracks.
In AUTO mode
1 Press 2 or 3 to adjust the level of the speaker outputting the
TEST TONE.
In MANU mode
1 Press 2 or 3 to adjust the level of the first speaker.
2 Press 5¥∞ to switch the TEST TONE to the next speaker.
3 Repeat 1 and 2 for each speaker.
If you are using a Sound Pressure Level (SPL) meter
Take the readings from your main listening position and adjust the
level of each speaker to 75 dB SPL (C-weighted/slow model).
5
When you have adjusted each speaker level, select
SETTING OK and press ENTER to return to the
previous screen
The MASTER VOLUME will return to its original position.
Next, proceed to CROSSOVER NETWORK below.
If you want to change a setting before proceeding.
Simply use the arrow buttons to go back.
6
Select EXIT with the 5¥∞ buttons and press ENTER to
return to the SYSTEM SETUP MENU.
S0URCE
DVD/LD TV/SAT
VCR1 VCR2
CD
TV VOL
TV FUNC
MENU
ENTER
STEREO
DIGITAL NR
MIDNIGHT
ADVANCED STANDARD
DSP
MUTE
TV
VOLUME
MD/
TAPE1
TUNER
TV CONT
RECEIVER
MULTI
OPERATION
CLASS MPX
MULTI CONTROL
DIRECT ACCESS
STATION
CHANNEL
TUNING
DTV ON/OFF DTV MENU
EXIT
DISC+10
GUIDE
TV CONTROL
FUNCTION
SIGNAL
SELECT
EFFECT
/CH SEL
2/dts
DIGITAL MULTI PROCESSING AMPLIFIER
REMOTE CONTROL UNIT
REMOTE
SETUP
SYSTEM
SETUP
BAND
SYSTEM
OFF
1
23
4
56
7
89
0
ENTER
Î
¶
73
1¡4¢
+
-
+
-
+
-
8
3,4
It is possible to set channels
levels independently for
Surround/dts, STEREO,
EXTERNAL DECODER and
each DSP mode for listening-
once purposes (see p.22 6).
This function is designed to
be used when you want to
change the levels temporarily
to hear one speaker louder.
You should return the
settings to their original state
when done.