Filter
Top Products
15
Connecting Your Equipment
PREPARATION
First turn the receiver off, then press the power button
while holding down the SPEAKERS button.
Choose the impedance setting by pressing the SPEAKERS button again.
You can choose the 8 Ω-16 Ω setting or the 6 Ω-8 Ω setting.
To check which impedance the amp is set to hold down the
SPEAKERS button for 2-3 seconds. You’ll get a display like the
one shown below right telling you the speaker impedance
setting.
7 Speaker terminals
1 Twist exposed wire
strands together.
2 Loosen speaker
terminal and insert
exposed wire.
3 Tighten terminal. The speaker terminals also
accept single banana
plugs.
(Refer to speaker manual
for details.)
3/8 in.(10 mm)
Speaker impedance
You can change the speaker impedance to suit the kind of speakers you have in your home system but we
recommend using speakers with an impedance of 8 Ω -16 Ω (the default setting). If you are using 6 Ω less than
8 Ω impedance speakers, you need to change the impedance setting.
(This display indicates an 6 Ω less than
8 Ω impedance setting)
(This display indicates a 6 Ω less
than 8 Ω impedance setting)
or
(This display indicates an 8 Ω-16 Ω
impedance setting)
dB
SIGNAL
SELECT
ANALOG
SP
A
VOLUME
dB
SIGNAL
SELECT
ANALOG
SP
A
VOLUME
dB
SIGNAL
SELECT
ANALOG
SP
A
VOLUME
STANDBY/ON
DSP
MODE
SIGNAL SELECTADVANCED STANDARD
STANDBY
AUDIO/VIDEO MULTI-CHANNEL RECEIVER
Digital Signal
P
STEREO
/DTS
N∫m¿ /?˘∫
PHONES
S-VIDEO
5-CHANNEL EQUAL POWER OUTPUT
VIDEO
EXTERNAL
DECODER INDIRECT LOUDNESS MID
N
SPEAKERS
–
–
BASS +
L AUDIO R
VIDEO INPUT
SPEAKERS
STANDBY/ON