Filter
Top Products
1 Press FUNCTION to select Mute.
Press FUNCTION repeatedly until Mute ap-
pears in the display.
2 Press c or d to select the desired set-
ting.
Each press of c or d selects settings in the
following order:
TEL mute (muting) 10dB ATT (attenuation)
20dB ATT (attenuation)
20dB ATT has a stronger effect than
10dB ATT.
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1 Press FUNCTION to select
FM tuning step.
Press FUNCTION repeatedly until
FM tuning step appears in the display.
2 Press c or d to select the FM tuning
step.
Pressing c or d will switch the FM tuning
step between 100 kHz and 50 kHz. The se-
lected FM tuning step will appear in the dis-
play.
Note
If seek tuning isperformed in 50 kHzsteps, sta-
tions maybe tuned in imprecisely.Tunein the sta-
tions with manualtuning or use seek tuning
again.
Setting the AM tuning step
The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
1,602 kHz allowable) to 10 kHz (530 1,640
kHz allowable).
1 Press FUNCTION to select
AM tuning step.
Press FUNCTION repeatedly until
AM tuning step appears in the display.
2 Press c or d to select the AM tuning
step.
Pressing c or d will switch the AM tuning
step between 9 kHz and 10 kHz. The selected
AM tuning step will appear in the display.
Switching the warning tone
If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
1 Press FUNCTION to select
Warning tone.
Press FUNCTION repeatedly until
Warning tone appears in the display.
2 Press a or b to turn Warning tone on
or off.
Pressing a or b will turn Warning tone on or
off and that status will be displayed (e.g.,
Warning tone ON).
Switching the flap auto open
For theft protection, the front panel opens
automatically and easily detaches. Flap auto
open is on as a default.
Initial Settings
En
54
Section
09