Filter
Top Products
5 Press SOURCE and hold until the unit
turns off.
6 Press OPEN to open the front panel.
7 Press and hold AUDIO to enter the auto
TA and EQ measurement mode.
8 Plug the microphone into the micro-
phone input jack on this unit.
9 Press a to start the auto TA and EQ.
10 Get out of the car and close the door
within 10 seconds when the 10-second
count-down starts.
The measurement tone (noise) is outputted
from the speakers, and auto TA and EQ be-
gins.
# When all speakers are connected, autoTA
and EQ is completedin about six minutes.
# Tostop auto TA andEQ, press any buttons
other than BAND.
# Tocancel auto TA andEQ part way through,
press BAND.
11 When auto TA and EQ is completed,
Complete is displayed.
When correct measurement of car interior
acoustic characteristics is not possible, an
error message is displayed. (Refer to Under-
standing auto TA and EQ error messages on
page 60.)
12 Press BAND to cancel the auto TA and
EQ mode.
13 Store the microphone carefully in the
glove compartment.
Store the microphone carefully in the glove
compartment or any other safe place. If the
microphone is subjected to direct sunlight for
an extended period, high temperatures may
cause distortion, color change or malfunction.
Note
Make sure you havedisconnected the micro-
phone before pressingOPEN to open or closethe
panel (an alert soundsif the mic is stillcon-
nected).
Audio Adjustments
En
51
English
Section
08