Filter
Top Products
Connecting up 02
15
En
Connecting auxiliary components
This system has a front panel audio input as
well as stereo analog inputs on the rear panel.
• See Using the USB interface on page 35 to
connect the front panel USB INPUT.
• Connect the LINE IN jacks on the rear
panel to an auxiliary playback component.
These include components such as a VCR,
cassette deck, or your TV. Connect using RCA
pin-plug stereo cables.
• Connect the front panel AUDIO IN mini-
plug jack to an auxiliary playback
component.
These include components like a digital audio
player or the analog audio output of a PC.
Connect using a 1/4" stereo mini-plug cable.
Connecting the power
After making sure that everything is connected
properly, connect the Media unit and the
Power unit with attached cord, then plug in the
power cord to the AC inlet, and the other end to
a mains power outlet.
Congratulations! You’re done setting up.
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull
out the plug by tugging the cord and never
touch the power cord when your hands are wet
as this could cause a short circuit or electric
shock. Do not place the unit, a piece of
furniture, etc., on the power cord, or pinch the
cord. Never make a knot in the cord or tie it
with other cords. The power cords should be
routed such that they are not likely to be
stepped on. A damaged power cord can cause
a fire or give you an electrical shock. Check the
power cord once in a while. When you find it
damaged, ask your nearest PIONEER
authorized service center or your dealer for a
replacement.
M
N
BAL 75 ½
SYSTEM
UB WOOFER
P
EAKERS (4 - 6 )
R
L
To AC outlet
Power unit
Media unit
AC IN
CX303_505_500.book Page 15 Wednesday, June 27, 2007 2:39 PM