Filter
Top Products
Switching the auxiliary setting
Auxiliary equipments connected to this unit
can be activated individually. Set each AUX
source to ON when using. About connecting
or using auxiliary equipments, refer to Using
the AUX source on page 49.
Switching the auxiliary 1 setting
% Touch AUX1 on the initial menu to se-
lect desired setting.
! VIDEO – an iPod with video capabilities
connected with 4-pole mini plug cable (e.g.,
CD-V150M)
! AUDIO – auxiliary equipment connected
with stereo mini plug cable
! OFF – No auxiliary equipment is connected
Switching the auxiliary 2 setting
% Touch AUX2 on the initial menu to turn
auxiliary 2 setting on.
# To turn auxiliary 2 setting off, touch AUX2
again.
Setting the rear output and
subwoofer controller
This unit’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (FULL) or subwoofer (S.W) con-
nection. If you switch the rear output setting
to S.W, you can connect a rear speaker lead
directly to a subwoofer without using an auxili-
ary amp.
! When the multi-channel processor (e.g.,
DEQ-P8000) is connected to this unit, you
cannot operate this function.
1 Touch REAR SP on the initial menu.
2 Touch c or d to switch the rear output
setting.
Touch c to select full-range speaker and FULL
appears in the display. Touch d to select sub-
woofer and S.W appears in the display.
# When no subwoofer is connected to the rear
output, select FULL.
# When a subwoofer is connected to the rear
output, set for subwoofer S.W.
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
35).
! If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
! Both rear speaker leads outputs and RCA rear
output are switched simultaneously in this
setting.
Selecting the OSD color
You can change the OSD color.
% Touch OSD COLOR on the initial menu
to select the desired color.
Each time you touch OSD COLOR it selects
colors in the following order:
BLUE (blue)—RED (red)—AMBER (amber)—
GREEN (green)—VIOLET (violet)
Selecting the illumination color
This unit is equipped with two illumination col-
ors, blue and red. You can select the desired il-
lumination color.
% Touch ILLUMI COLOR on the initial
menu to select the desired color.
Operating this unit
En
42
Section
03