Filter
Top Products
Pelco Manual C550M-E (8/97) 25
8.1 OPTIONAL ACCESSORIES
A9000 Auto/random scan, plug-in mod-
ule.
AUX2000 Auxiliary function relay box for
control of wiper/washer functions.
AUX9000 Auxiliary function wiring harness.
Required for use with AUX2000
and all indoor Coaxitron/Wiretron
receivers (supplied with outdoor
receivers).
CX900TLC Local test board, plug-in module.
EA2000 Coaxitron equalizing video/con-
trol amplifier. This unit is highly
effective in maintaining picture
quality. See Section 9.0 for spe-
cific distances.
8.2 RECOMMENDED CABLES
C1906 Pretested 6 foot (2 m) cable for
use with ED2820, ED2920,
SB2800, SS2000, and SS3000
series enclosures and inverted
PT180-24P, PT280-24P pan/
tilts.
C1906/PP Same as C1906 except for use
with preset pan/tilts.
C1925 Pretested 25 foot (8 m) cable for
use with ED2820/ED2920,
SB2800, SS2000 and SS3000
series enclosures and inverted
PT180-24P, PT280-24P pan/
tilts.
C1925/PP Same as C1925 except for use
with preset pan/tilts.
C2506 Pretested 6 foot (2 m) cable for use
with SB2500 series enclosures.
C2525 Pretested 25 foot (8 m) cable for
use with SB2500 series enclosures.
C6806 Pretested 6 foot (2 m) cable for
use with PT680-24P/PT680-
24SL pan/tilts. Not for inverted
operation.
C6806/PP Same as C6806 except for use
with preset pan/tilts.
C6825 Pretested 25 foot (8 m) cable for
use with PT680-24P/PT680-
24SL pan/tilts. Not for inverted
operation.
C6825/PP Same as C6825 except for use
with preset pan/tilts.
WH1900-06 6 foot (2 m) wire harness pre-
assembled with bare wire and
37-pin connector for use with
SB1900 series enclosures.
WH1900-25 Same as WH1900-06 except 25
feet (8 m) long.
9.0 SPECIFICATIONS
ELECTRICAL
Input Voltage: 120 VAC, 60 Hz Transmitter
and Receiver (strapable for 230
VAC, 50 Hz)
Power
Consumption:
Transmitter 2.5vA
Receiver 5vA (120 VAC or 24 VAC)
Pan/Tilt Supply 140vA Max. (120 VAC)
50vA Max. (24 VAC)
Lens Supply 0-4vA Max.
Camera Supply 15vA (typical)
Control Method: 15-pulse train (pulse width
modulated) superimposed on the
video signal during the vertical
blanking interval by the control
transmitter. Pulse train occupies
1 TV line period.
Pulse Amplitude: Approximately 1V p-p added to
video signal, 333 kHz nominal
Connectors:
Control
Transmitter 3 BNC connectors
Receiver 2 BNC connectors for video in-
put and output
37-pin AMP CPC for control
output (mate supplied)