Filter
Top Products
Advanced Settings
29
Setting Item Default Value Setting Details
DHCP Enable "Enable": Auto configuration by DHCP
"Disable": Manual configuration without DHCP
If selecting "Disable", you must set "IP
Address", "Subnet Mask", "Gateway", and
"DNS Server" manually.
IP Address - Displays/Sets the IP address.
Subnet Mask - Displays/Sets the subnet mask.
Gateway - Displays/Sets the gateway.
DNS Server - Displays/Sets the primary DNS server.
Proxy URL - Displays/Sets the proxy server URL.
Proxy Port - Displays/Sets the proxy server port number when
you enter "Proxy URL".
Network Check - Confirms the status of the network connection.
Press ENTER when "Start" is displayed.
Wait for a while if "12. Network Setup" is not shown on the screen. It will appear when the network
function is started up.
13. Bluetooth (Bluetooth Setup)
Setting Item Default Value Setting Details
Bluetooth On Enables/Disables the unit to pair with
Bluetooth-enabled device.
"On": Enables the Bluetooth function and allows
the unit to pair with Bluetooth-enabled device.
Set this function to "On" when configuring the
settings related to Bluetooth.
"Off": When not using the Bluetooth function.
Direct Change On Automatically changes the input selector to
"BLUETOOTH" when a Bluetooth-enabled
device is connected.
"On": To enable this function.
"Off": To disable this function.
When the input selector is not selected
automatically, set this function to "Off" and
change the input selector manually.
Setting Item Default Value Setting Details
Auto Reconnect On Automatically reconnects to the Bluetooth-
enabled device connected last when you
change the input selector to "BLUETOOTH".
"On": To enable this function.
"Off": To disable this function.
This function may not work depending on
your Bluetooth-enabled device.
Wakeup Off Automatically wakes up the unit when it is on
standby by connecting a Bluetooth-enabled
device.
"On": To enable this function.
"Off": To disable this function.
Setting this function to "On" increases
the power consumption even when the
AV receiver is on standby. However, the
increase in power consumption is kept to
a minimum by automatically entering the
HYBRID STANDBY mode, where only the
essential circuit is operating.
When "Direct Change" is set to "Off",
"Wakeup" is fixed to "Off".
Pairing Info - This function initializes the information of a
previous pairing information stored in the unit.
Pressing ENTER when "Clear" is displayed
initializes the pairing information stored in this
unit.
This function does not initialize the pairing
information on the Bluetooth-enabled device.
When pairing the unit with the device again,
be sure to clear the pairing information on
the Bluetooth-enabled device in advance.
For information on how to clear the pairing
information, refer to the Bluetooth-enabled
device's instruction manual.
Device - Displays the name of the Bluetooth-enabled
device connected to the unit.
The name is not displayed when "Status" is
"Ready" and "Pairing".