Filter
Top Products
Advanced Settings
28
Setting Item Default Value Setting Details
InstaPrevue - This function is related to the preview thumbnails
of the video input through HDMI, which will be
displayed using "InstaPrevue" in the Home menu.
Depending on the video source, the preview
thumbnails configured in "InstaPrevue" may
not be displayed properly.
Sub Window Multi Allows you to set how to display preview
thumbnails.
"Multi": Displays all the thumbnails of HDMI IN 1,
2, 3, 4 and 5 at once.
"Single": Displays thumbnails of HDMI IN 1, 2, 3,
4 and 5 individually.
Position Bottom/LowerR Allows you to set the display position of preview
thumbnails.
When setting "Sub Window" to "Multi": Select
from "Top", "Bottom", "Left" and "Right".
When setting "Sub Window" to "Single":
Select from "UpperL", "UpperR", "LowerL" and
"LowerR".
12. Network Setup
Make the network setting.
When LAN is configured with a DHCP, set "DHCP" to "Enable" to configure the
setting automatically. ("Enable" is set by default) To assign fixed IP addresses to each
component, you must set "DHCP" to "Disable" and assign an address to this unit in
"IP Address" as well as set information related to your LAN, such as Subnet Mask and
Gateway.
Setting Item Default Value Setting Details
Network Standby Off This function allows you to turn on the power of
the AV receiver via network using an application
such as Onkyo Remote.
"On": When using this function
"Off": When not using this function.
When "Network Standby" is used, the power
consumption increases even when the AV
receiver is on standby. However, the increase
in power consumption is kept to a minimum by
automatically entering the HYBRID STANDBY
mode, where only the essential circuit is
operating.
Wi-Fi Off Allows you to connect the unit to Internet via
wireless LAN router.
"On": Wireless LAN connection
"OFF": Wired LAN connection
Wi-Fi Setup - Allows you to configure wireless LAN settings by
pressing ENTER when "Start" is displayed.
Wi-Fi Status - Displays the information of the connected access
point as follows.
"SSID": SSID of the connected access point.
"Security": Security method of the connected
access point.
"Signal": Signal strength of the connected access
point.
"SSID": SSID of the connected access point.
MAC Address - This is the MAC address of the AV receiver.
This value is specific to the component and
cannot be changed.