Filter
Top Products
62
Using remote controller
Controlling an Onkyo DVD player
Make sure that you point the remote controller toward the sensor
on the Onkyo DVD player.
1. Press the DVD MODE button.
“DVD” appears in the remote controller display.
2. Press the desired operation button. The
buttons shaded in the figure to the left are the
operation buttons that can used to control an
Onkyo DVD player.
ON/STNBY: Turns the DVD player on and off
DVD SET: Enters the DVD setup menu
DVD player on-screen buttons
MENU: Displays the menu
: Moves the cursor
ENTER: Confirms the selection
RETURN: Return buttons
DVD player buttons
: Chapter/Track down
: Chapter/Track up
: Play
: Stop
: Fast reverse
: Fast forward
: Pause
OPEN/CLOSE r: Open/close the disc tray
0, 1 to 9, +10: Numeric keys
ENT: Confirm
You may also use the following buttons:
VOL : Adjusts the volume at the TX-DS787
MUTING: Activates the muting function at the TX-DS787
Note:
The ENT button on the bottom right of the numeric keys has the
same function as “ENTER” of the ENTER/cursor button.
SAT, CABLE, VCR, and TV MODE buttons
No preset codes are programmed into the SAT, CABLE, VCR, and
TV MODE buttons. You can use these buttons to program the
remote controller signals of other devices (see page 63).
You may use the following buttons:
VOL : Adjusts the volume at the TX-DS787
MUTING: Activates the muting function at the TX-DS787
OPEN/CLOSEREC
AUDIO MUTING
DISCTRACK
DVD
CD
PH
TUN
T2T1
V1
STEREO
123
654
7
+
10 0
ENT
89
SURROUND THX DSP
LEVEL
+
CH SELRe-EQ
LEVEL
–
DIMMER
HOME THEATER CONTROLLER
RC-390M
LATE NIGHT
DIRECT DSP
V2 V3 V
–
DVD MODE
MENU
DVD SET
ON
STNBY
RETURN
OPEN/CLOSEREC
AUDIO MUTING
DISCTRACK
DVD
CD
PH
TUN
T2T1
V1
STEREO
123
654
7
+
10 0
ENT
89
SURROUND THX DSP
LEVEL
+
CH SELRe-EQ
LEVEL
–
DIMMER
HOME THEATER CONTROLLER
RC-390M
LATE NIGHT
DIRECT DSP
V2 V3 V
–
DVD
operation
buttons
Numeric keys,
ENT
ENTER
Cursor
button
SAT, CABLE, VCR,
and TV MODE