Filter
Top Products
22
REMOTE
CONTROL
PRE
OUT
R
L
R
L
DIGITAL
OUTPUT
(
OPTICAL
)
DIGITAL
INPUT
(
OPTICAL
)
1
FRONT
SURR
VIDEO
S VIDEO
ZONE 2
MAIN
IR IN
ANTENNA
AM
FM
75
Strip away the insulation
from the end of the cable,
then fully insert the
stripped end of the cable.
(Indoor) AM loop antenna
Connecting antennas
Connecting the AM antenna cable
1. Press down the lever.
2. Insert the wire into the hole.
3. Release the lever.
12
3
Insert into the hole.
FM antenna
USA and
Canadian
models
Other
models
Hint:
Either of the split ends of the AM antenna can be connected to
either terminal. Unlike speaker cabling, there is no polarity for
AM broadcast signals.
Connecting the included antennas
Connecting the FM indoor antenna:
The FM indoor antenna is for indoor use only. During use, extend
the antenna and move it in various directions until the clearest
signal is received. Fix it with push pins or similar implements in
the position that will cause the least amount of distortion.
If the reception is not very clear with the attached FM indoor
antenna, the use of an outdoor antenna is recommended.
Connecting the AM loop antenna:
The AM loop antenna is for indoor use only. Set it in the direction
and position where you receive the clearest sound. Put it as far
away as possible from the TX-DS787, televisions, speaker cables,
and power cords.
When reception is not satisfactory with the attached AM loop
antenna alone, connection of an outdoor antenna is recommended.
To the use the tuner of TX-DS787, it is necessary to prepare the
supplied FM and AM antennas.
• Adjustment and placement of the FM and AM antennas for
better reception must be done while listening to a station
broadcast.
• If better reception cannot be obtained, then placement of an
outside antenna is recommended.
Assembling the AM loop antenna
Assemble the loop antenna as shown in the illustration.
• Refer to the next page for details on connecting the AM loop
antenna.