En-
40
Setting the Clock
If you have a North American model, use the following
procedure to set the clock. If you have a European
model, the clock is set by the AccuClock function.
The AccuClock function sets the clock automatically the
very first time the CBX-300 is plugged into a wall outlet
(see page 19).
If for some reason the clock cannot be set automatically,
use the following procedure to set it manually. Note that
when the clock is set manually, it will not be updated
automatically.
Displaying the Day and Time
To display the day and time, press the remote controller’s
[CLOCK CALL] button. Press the button again or per-
form another operation to cancel the time display.
If the CBX-300 is on Standby, the day and time will be
displayed for 8 seconds.
While the CBX-300 is on, the day and time are displayed
continuously.
Using the 12- or 24-hour Format
To change the time format between 12-hour and 24-hour,
while the day and time are shown on the display, press
the [DISPLAY] button.
Displaying the Time in Standby Mode
To set the CBX-300 so that the time is displayed contin-
uously while it’s on Standby, turn on the CBX-300, and
then press and hold its [STANDBY/ON] button for 2
seconds. To turn off this feature, repeat this procedure.
Note that having the time displayed in Standby mode
will consume more power.
Setting the Clock
1
Press the [TIMER] button repeat-
edly until “Clock” appears.
If you have a North American model, go
to step 4.
2
Press [ENTER].
3
Use the Previous and Next [ ]/
[] buttons to select
ManualAdjust.
Tip:
• If the AccuClock function is working,
pressing the [YES/MODE] button will
set the clock based on the RDS CT
information (see page 41, step 6).
4
Press [ENTER].
/
ENTER
TIMER
CLOCK
CALL
DISPLAY
STANDBY/ON
Number
button
5
Use the Previous and Next [ ]/
[] buttons to select the day of
the week.
You can select: SUN, MON, TUE, WED,
THU, FRI, or SAT.
6
Press [ENTER].
To change the time format between 12-
hour and 24-hour, press the [DISPLAY]
button.
7
Use the remote controller’s num-
ber buttons to enter the current
time.
You can also use the Previous and Next
[ ]/[ ] buttons.
For the 12-hour format
, use the remote
controller’s [
>
10]
button to select A.M.
or P.M.
8
Press [ENTER].
The clock is set and the second dot starts
flashing.