Filter
Top Products
SOURCE-POWER EDITING
To edit the power commands for the source compo-
nents:
Step 1 - Press and hold the PROGRAM button.
The
PROGRAM LED lights, the TUNER 1/2 LED
lights, the
SEQUENCE LED blinks, and the ENTER IR
LED is on.
Edit Power for Source 3: Tap the NEXT button twice.
The
SOURCE 3/4 LED is RED, and the POWER OR
DISCRETE "ON"
LED blinks.
Skip to Step 2.
Edit Power for Source 4: Tap the NEXT button until
the
SOURCE 3/4 LED is GREEN and the POWER OR
DISCRETE "ON"
LED blinks.
Skip to Step 2.
Edit Power for Source 5: Tap the NEXT button until
the
SOURCE 5/6 LED is RED and the POWER OR
DISCRETE "ON"
LED blinks.
Skip to Step 2.
Edit Power for Source 6: Tap the NEXT button until
the
SOURCE 5/6 LED is GREEN and the POWER OR
DISCRETE "ON"
LED blinks.
Skip to Step 2.
Edit Power for Source 7: Tap the NEXT button until
the
SOURCE 7/8 LED is RED and the POWER OR
DISCRETE "ON"
LED blinks.
Skip to Step 2.
Edit Power for Source 8: Tap the NEXT button until
the
SOURCE 7/8 LED is GREEN and the POWER OR
DISCRETE "ON"
LED blinks.
Skip to Step 2.
Step 2 - If the component has a single power IR com-
mand for both ON and OFF, teach the power IR com-
mand by pressing the power button on the compo-
nent's factory remote.
or
If the component has discrete ON and OFF com-
mands, teach the discrete ON command by pressing
the ON button on the source component's remote
control. The
ENTER IR LED blinks.
Step 3 - Immediately after capturing the IR command,
test it by pressing the
TEST IR button. If the source
component does not respond correctly to the IR com-
mand, try reteaching the command at various dis-
tances from a half-inch (roughly a centimeter and a
quarter) to three feet (almost a meter).
Step 4 - Tap the NEXT button. The POWER ON LED
turns off and the
DISCRETE OFF LED blinks RED.
Step 5 - If the component has a single power com-
mand for both ON and OFF, press the
NEXT button
again and continue to program the system.
or
If the component has a discrete ON and OFF com-
mand, teach the discrete OFF command. The
ENTER
IR
LED blinks.
Step 6 - Immediately after capturing the IR command,
test it by pressing the
TEST IR button. If the source
component does not respond correctly to the IR com-
mand, try reteaching the command at various dis-
tances from a half-inch (roughly a centimeter and a
quarter) to three feet (almost a meter).
Step 7 - Tap the PROGRAM button to exit programming.
69
PROGRAM EDITING STEPS
IR COMMAND EDITING
To edit the individual IR commands for control of the
source components:
Step 1 - Press and hold the PROGRAM button.
The
PROGRAM LED lights, the TUNER 1/2 LED
lights, the
SEQUENCE LED blinks, and the ENTER IR
LED is on.
Edit IR Commands for Source 3: Tap the NEXT but-
ton until the
SOURCE 3/4 LED is RED, and the IR
COMMANDS
LED blinks.
Skip to Step 2.
Edit IR Commands for Source 4: Tap the NEXT but-
ton until the
SOURCE 3/4 LED is GREEN, and the IR
COMMANDS
LED blinks.
Skip to Step 2.
Edit IR Commands for Source 5: Tap the NEXT but-
ton until the
SOURCE 5/6 LED is RED, and the IR
COMMANDS
LED blinks.
Skip to Step 2.