Filter
Top Products
PROGRAM
ENTER
IR
NEXT
66
SYSTEM PROGRAMMING STEPS
Step 6 - Press the NEXT button.
If the source component does not respond correctly to the IR command, press again the same Function Button on the Niles
R-8 Remote.
The
ENTER IR LED lights RED. Reteach the command and test again. If the source component still does not respond cor-
rectly, try reteaching the command at various distances from a half-inch (roughly a centimeter and a quarter) to three feet
(almost a meter). If it still doesn’t work, see Alternate IR Learning Mode on page 68.
Step 8 - Teach the Source 3 IR command.
TUNER12
SOURCE34
SOURCE
POWER OR
DISCRETE "ON"
DISCRETE "OFF"
SOURCE
5
7
6
8
IR COMMANDS
POWER
PROGRAM
ENTER
IR
NEXT
RED LED GREEN LED
The DISCRETE “OFF”
LED turns OFF.
The IR COMMANDS
LED blinks RED.
Step 7 - On the Niles R-8 Remote, press a Function
Button that corresponds to the Source 3 IR command
you wish to teach.
TUNER12
SOURCE34
SOURCE
SOURCE
5
7
6
8
PROGRAM
ENTER
IR
NEXT
RED LED GREEN
The ENTER IR LED lights RED.
TUNER12
SOURCE34
SOURCE
POWER OR
DISCRETE "ON"
DISCRETE "OFF"
SOURCE
5
7
6
8
IR COMMANDS
POWER
PROGRAM
ENTER
IR
SEQUENCE
NEXT
TEST IR
RED LED GREEN LED
The ENTER IR LED turns OFF.
Immediately after capturing the IR command, test
it by pressing the TEST IR button.
Step 9 - Repeat Steps 7 and 8 until you have taught all commands for Source 3.
The ENTER IR
light turns off.