Filter
Top Products
INSTALLATION SETTINGS
VOLUME SETTINGS
The ZR-8630AV has three useful volume features with customizable settings:
Maximum Turn ON and Source Change Volume Level
Maximum Turn ON and Source Change Volume prevents a zone from playing too loudly when it turns on or
if its selected source changes.
When a zone turns ON individually, it always turns ON to its last volume setting—unless the last volume
setting is greater than the Maximum Turn ON and Source Change Volume level set in the memory of the
ZR-8630AV. In that case, it turns ON to the Maximum Turn ON and Source Change Volume level.
When a zone selects a new source, the volume setting does not change—unless the zone’s current volume set-
ting is greater than the Maximum Turn ON and Source Change Volume level. In that case, it changes to the
Maximum Turn ON and Source Change Volume level.
The range for Maximum Turn ON and Source Change Volume is 30 through 63. The factory default is 45. To
adjust it up or down, see Changing Volume Settings below.
ALL ON Volume Level
In response to a system-wide ON command, zones that are OFF turn ON to the ALL ON Volume Level set in
the memory of the ZR-8630AV. Volume levels in zones that already are ON don’t change during a system- wide
ON command. The range for ALL ON Volume Level is 1 through 63. The factory default is 22. To adjust it up
or down, see Changing Volume Settings below.
Page Volume Level
When a page occurs, all zones broadcast it at the Page Volume Level set in the memory of the ZR-8630AV. The
range for PAGE Volume Level is 1 through 63. The factory default is 35. To adjust it up or down, see Changing
Volume Settings below.
Changing Volume Settings
1.
Turn the ZR-8630AV ON.
2. Press and hold the PROGRAM button for two seconds, until the LCD display shows "PGM MODE.”
3. Press the Tuner Select button.
The LCD display shows "MxVol #" (for Maximum Turn ON and Source Change Volume Level).
4. Press the Station Scan + button to increase MxVol or press the Station Scan - button to decrease MxVol.
5. Press the Tuner Select button or NEXT button to advance to “OnVol #” (for ALL ON Volume Level) and
repeat Step 4 to adjust.
6. Press the Tuner Select button or NEXT button to advance to “PgVol #” (for Page Volume Level) and repeat
Step 4 to adjust.
7. Tap the PROGRAM button to exit programming.
61