Filter
Top Products
- 25 -
TIME
REC REMAIN
L
R
-dB
over
0
26
1220
40
00
-dB
INT
MIC
PM
Then either:
8a. Press and release the FWD/+ button
or
the -/REW button
to tab to another menu
choice, or
8b. Press and release the
MENU/STORE
button to write the menu changes and return
to stop mode, or
8c. Press and release the CANCEL button
to
cancel any menu changes and return to stop
mode.
The Menu choices are:
Date/Time – For setting or changing the Date and
Time associated with when an audio track (file)
was created.
DateForm – For selecting the date order.
Algor/File – For setting or changing the recording
compression algorithm, associated bit rate, audio
file type, and channels recorded.
M. Track – Turn manual track incrementing
feature on or off.
SeamlsPly – Turn the Seampless play feature on
or off.
S.Skip – Turn Silent Skip feature on or off, set the
number of seconds the dB level must meet or
exceed the set threshold, and set the dB threshold
level.
A.Cue – Turn the Auto Cue feature on or off, set
the number of micro-seconds the dB level must
meet or exceed the set threshold, and set the dB
threshold level.
S.Play – Turn the single track play feature on or
off.
Beep – Turn the beep on or off.
A.PowOff – Enable or disable the Automatic
Power Off feature.
Batt_Type – Set the battery type.
RemoteMode – Set the effect of the optional
wired remote switch.
ID1 – Set the description ID code for broadcast
wave file recordings.
ID2 – Set the origin ID code for broadcast wave
file recordings.
ID3 – Set the origin reference ID code for broad-
cast wave file recordings.
Default – Reset all Menu settings to factory
default settings.
How to set or change the Date and time
The date and time are written on each audio
track (file) when the track is started. When an
audio track is viewed on a computer this date
and time appears as when the file was 'modi-
fied'. (US date format is illustrated.)
1. From stop, press and hold the
MENU/
STORE button for about 2 seconds. MENU
will appear (flashing) in the display.
Example
display:
2. While MENU is flashing (for about 3 seconds)
press and release the ENTER button
.
The Date/Time
Menu choice
will appear.
(If the flashing MENU times out start over at 1.)
3. Press and release the ENTER button
again. The current date and time information
will be displayed with the month flashing.
Example
display.
4. With the month flashing press and release
the FWD/+ button or the -/REW but-
ton
to tab through the months. When the
month is correct, Press and release the
ENTER button
.