Filter
Top Products
MIC ATTEN
0dB
-20dB
FLAT
ANC
LEVEL CONT.
LIMITER
ALC
MANUAL
OFF
ON
EDL PLAY
STEREO
L
ANALOG OUT
R
OFF
ON
AUTO MARK
OFF
ON
PRE REC
MARK
A-B REPEATINPUT
EDIT
SINGLE
OFF
ALL
OFF
ON
INPUT LOCK
7
OFF
ON
INPUT LOCK
a
TIME
REC REMAIN
L
R
-dB
over
0
26
1220
40
00
-dB
INT
MIC
8
9
6. PRE REC switch
Lets you turn off pre
record cache if it is not
desired.
When power is on the PMD670 is constantly
saving 2 seconds of audio input. This is called
pre record cache. When recording is started by
sliding the REC switch, or resumed from REC
PAUSE by sliding the REC switch the pre-re-
corded 2 seconds is recorded.
OFF: Turns the 2 second pre-record cache off.
ON: Leaves the 2 second pre-record cache on.
Factory default: PRE REC switch at ON.
OFF ON
PRE REC
LR
STEREO
ANALOG OUT
6
- 15 -
MIC ATTEN
0dB
-20d
B
7. INPUT LOCK switch
The INPUT LOCK switch
lets you lock your selected
input settings with a switch
covered by the Security
cover.
OFF: When the INPUT LOCK switch is at OFF
push and release the INPUT button (a) to tab
through the input choices. The selection “times
out” to the displayed input choice in 5 seconds.
Example
display:
mono with INT MIC
ON: When the INPUT LOCK switch is at ON
pushing the INPUT button (a) does nothing
(skips the input selection choices).
Factory default: INPUT LOCK switch at OFF.
8. ANALOG OUT switch
Selects the audio output
channel for playback.
Applies to playback output to LINE OUT, and
Internal speaker or headphones.
L: Audio recorded on the Left channel is output to
both the left and right output channels.
If the recording is dual level mono (a mono input
was recorded onto both the right and left channels)
the L setting outputs the audio at a normal level
while the right is reduced -15dB.
STEREO: Audio recorded on the Left channel is
output to the left output channel, and audio re-
corded on the Right channel is output to the right
output channel. Both channels are output to the
internal speaker.
R: Audio recorded on the Right stereo channel is
output to both the left and right output channels.
Factory default: ANALOG OUT switch at STEREO.
9. MIC ATTEN switch
The microphone attenuation
switch permits the direct use
of microphones that differ in
sensitivity.
0dB: No microphone attenuation.
-20dB: Input from a microphone(s) connected to
the XLR MIC IN jacks is cut by -20dB.
Factory default: MIC ATTEN switch at 0dB.