Filter
Top Products
53
english
JABRA PRO 9460, 9460DUO AND 9470 USER MANUAL
PaiRing and connecting with otheR Bluetooth deviceS9.2
Pairing the Base with a Mobile Phone
To use Bluetooth, you must set up the wireless communication between the Jabra PRO 9470 Base and your
mobile phone by pairing them. The setup wizard helps you to do this during the initial setup but you can run the
wizard at any later time.
1. Launch the mobile-phone part of the setup wizard on the Jabra PRO base as described in Section 8.9: Re-running
the Setup Wizards. This puts the base into pairing mode, which causes it to advertise itself as available for
pairing.
2. Make sure that Bluetooth is active on your mobile phone and put your phone into Bluetooth pairing mode.
The exact procedure for doing this varies by mobile phone manufacturer and model — see your mobile
phone manual for details.
3. Your phone now looks to see if any nearby Bluetooth devices are advertising themselves for pairing. Use
your phone’s controls to identify and select the “Jabra PRO 9470” device. Your phone might also ask for the
headset’s pass code. The pass code for all Jabra devices is 0000 (four zeros).
JABRA PRO
4. Your phone attempts to connect to the base and then shows you the result of the attempt. If the attempt
fails, please try again. If you are still having trouble, please check your mobile phone documentation and/or
contact technical support for Jabra and/or your mobile phone.
Note: All communications between your Jabra PRO 9470 Base and your mobile phone are encrypted, so
others will not be able to intercept and understand your conversation. Establishing this encryption is an
important part of the pairing process.
Managing Bluetooth Connections
Just because two devices are paired, does not necessarily mean they are connected, which means that the link
between them is active. Usually, the base manages its Bluetooth connection automatically even as you take
the mobile phone out of range and/or turn off the devices from time to time. However Jabra PRO does provide
controls for managing the connection manually if necessary, as described below.
To drop the connection from the base to your mobile phone (for example, because you would like to connect
your mobile phone to another device), do one of the following:
- Use the base touchscreen menus as described in Section 8.8: Setting General User Preferences.
- Use the menu system on your mobile phone as described in your phone’s documentation.
If two paired devices are turned on and in range but fail to connect automatically, you can connect manually
using the base and/or mobile phone menu commands.