Filter
Top Products
21
english
JABRA PRO 9460, 9460DUO AND 9470 USER MANUAL
4. As you speak with your friend, adjust the mic.-level control on the Jabra PRO touchscreen (Desk phone setup
wizard, manual setup) until your friend tells you that your voice sounds clear (loud enough) but not distorted
(too loud). The desk phone part of the setup wizard guides you through. Remind your friend not to adjust his
or her own volume during the test.
If your best mic.-level setting turns out to be the loudest possible and you found more than one best position
for the clear dial-tone switch, then move the clear dial-tone switch to the alternative setting and try again to
find the best mic.-level together with your friend. If this time the mic.-level is not set to the maximum, then
keep this new combination of settings.
5. Press the headset button on your desk phone (or replace the handset) to hang up. Then dock the headset
(the audio link from the headset to your desk phone closes automatically when you dock the headset).
Your headset is now ready for use.
uSing a handSet lifteR oR electRonic hookSwitch4.6
With traditional desk phones, you must lift the handset (or press a desk phone headset button, if present)
whenever you want to place or receive a call. However, you can automate this connection by adding one of the
following:
- GN1000 Remote Handset Lifter, which will work with nearly any phone.
- An electronic hookswitch connection, which requires a supported desk phone and a phone-specific adapter
from Jabra.
Electronic solutions such as these enable you to answer an incoming call when away from your desk simply by
pressing a button on the headset. They also tell the base when your desk phone is ringing, thereby setting the
desk phone as the current target phone automatically. The GN1000 and most electronic hookswitch solutions
support ring detection.
Connecting to the GN1000 Remote Handset Lifter
A remote handset lifter gives you remote call control with a Jabra PRO headset up to 150 m away from your desk.
It lets you answer calls, end calls and transfer ring tones to the headset.
The GN1000 Remote Handset Lifter is an accessory available from Jabra. It is a motorized device that physically
lifts the handset when you use controls of your headset or base. You can use the handset lifter with nearly any
type of desk phone — including phones that also happen to have electronic hookswitch support.
Figure 16: Connecting to a GN1000 Remote Handset Lifter
To connect the Jabra PRO base to a GN1000 RHL handset lifter:
1. Connect the Jabra PRO base to your desk phone using the standard in-line setup as described in Section 4.4:
Connecting the Base to Your Desk Phone. Do not use your desk phone’s headset port if it has one.
2. Assemble the GN1000 RHL handset lifter and attach it to your desk phone as described in the lifter’s
documentation.
3. Connect the control cord attached to the GN1000 to the port marked
on the Jabra PRO base. Press it in
until you hear or feel the soft click of the connector tab popping into place.
4. The base and handset lifter are now connected.