Filter
Top Products
Tape Input and Output
The KPS 25sc has a discrete tape input and
output. The tape output is used to send an in put
signal from S-1, S-2, S-3, or B-1 to a recording
device or processor. You can use the tape fea-
ture in two ways:
1. Use the tape input to compare the output
signal of a three-head analog tape recorder
to the output signal of an audio source,
when making a recording. To activate this
function, select an audio source for record-
ing using either the S-1, S-2, S-3, or B-1
input selector buttons (20-23) or keys.
Press the tape button (24) or tape key
the Tabletop Remote Control to switch
between the tape recorder output (red LED
illuminated) and the input source (red LED
not illuminated).
2. Use the tape output to create a processor
loop, when the KPS 25sc is connected to a
graphic equalizer or other ancillary equip-
ment. To activate this function, connect the
equipment to the KPS 25sc tape outputs
(33) as described in the equipment manu-
facturer’s manual. Press the tape button
(24) or tape key on the Tabletop Remote
Control to switch between the processor
output (red LED illuminated) and the input
source (red LED not illuminated).
Note
When changing sources, lower the volume to
off or mute the output. This ensures that the
next source played does not damage your sys-
tem with a high output transient.
Krell KPS 25sc 25