Filter
Top Products
Installing the Acrylic Cover, continued
CONNECTING THE FLEX FOIL
CABLE
To connect the flex foil cable, follow the easy
steps described below and illustrated in Figure
2 on page 8.
IMPOFITANT
Do not crimp the flex foil cable, either manually
or with pliers or other tools. Crimping will dam-
age the flex foil cable and make ff inoperable.
Use care when inserting the flex foil cable. Its
edges can be sharp.
1.
Locate the flex foil cable (D) attached to the
acrylic cover and the flex foil receptacle (E)
on top of the KPS 25sc. Make sure the flex
foil receptacle is open (see detail E.1).
2. Using your fingers, carefully align the flex
foil cable (D) so that its tip is parallel to the
open flex foil receptacle. Again using your
fingers, gently feed the flex foil cable (D)
into the flex foil receptacle until the cable
touches the rear of the receptacle (see
detail E.2).
3. Close the flex foil receptacle by sliding the
sleeve toward the front of tl~e KPS 25sc
(see detail E.3). There will be an audible
click when the flex foil cable locks into the
closed position (see detail E.4).
4. Recheck that the flex foil cable ~s curved but
not crimped.
The acrylic cover is now ready for operation.
ADJUSTING THE COVER
CLOSING SPEED
You can adjust the cover closing speed using
the lid damper adjust screw (37) on the back
panel. Adjustments can be made while the
cover is up or down.
To decrease speed, turn the screw
clockwise in 1/8 inch increments.
To increase speed, turn the screw coun-
terclockwise in 1/8 inch increments.
IMPORTANT
The lid damper adjust screw is very sensitive.
Always support the cover while adjusting the
screw to keep the cover from closing too fast.
10 Krell KPS 25sc