Filter
Top Products
— 43 —
Installation
■
Remove the factory-installed car stereo and install the unit that
was assembled in Assembly.
Install the mounting sleeve (Accessory3) on the car side with
the face labeled "UP" facing upwards.
1
UP
Connect the wires from the car side, and then insert the
assembled unit into the mounting sleeve.
3
Press in as far as this position.
Bend the tabs of the mounting sleeve
(Accessory
3)
with a
screwdriver or similar utensil and attach it in place.
2
Antenna
cable
Z919
Accessory89
Hole
In the case of an Audi, a Volkswagen, or any other model where
rubber bushes (Accessories 8 and 9) are used, install the unit
so that the rubber bushes on the rear panel fit into the holes on
the car side.
NOTE
Align the holes in the unit (two locations on each side) with the
vehicle mounting bracket and secure the unit with the
accessory screws.
Accessory!
(M5X6mm)
Z919
Installing in Japanese-Made Cars
■