Filter
Top Products
— 13 —
"KEX.P." : Recalling the kenwood preset sound setting
Press the preset buttons (#1-6).
Setting values: #1;Flat, #2;Rock, #3;Top40, #4;Jazz, #5;Easy,
#6;Scan of #1-5
• This mode is available only when the Sound coordinate system
is on. (page 35)
• You can call the following settings with this function; bass
center frequency, bass level, bass quality factor, bass extension,
treble center frequency, and treble level setting.
NOTE
Adjust various parameters of sound quality.
Press the AUD button repeatedly and switch the display to
“AUDIO CTRL” to enter the audio control mode.
Pressing the button cycles through Audio control mode,
Crossover control mode, and Control mode off.
Selecting mode
Press either the FM or AM button.
Each time the button is pressed, the adjustment mode will
change.
Please refer to the following for the contents of the adjustment
modes.
Source tone memory
Each source ( CD, FM, AM and disc changer ) has its own
memory in which to store the KEX.P, bass center frequency, bass
level, bass quality factor, bass extension, treble center frequency,
and treble level settings.
The settings made for a particular source are recalled
automatically whenever you use that source ( for example, FM
mode uses the tone settings made for FM, AM for AM, etc.).
Adjust each mode
Press the 4/¢ button.
Please refer to the following for the adjusting values.
Press the AUD button twice to end the audio control mode.
4
3
NOTE
2
1
Audio Control Setting
"BASS f" : Adjust the center frequency of the bass.
Setting values: 60 / 70 / 80 / 100 (Only when the bass quality
factor is set to 1.00, 1.25 or 1.50) / 150 (Only when the bass
quality factor is set to 2.00) Hz
This mode is available only when the Sound coordinate system is
on. (page 35)
NOTE
"BASS" : Adjust the bass level.
Setting values: - 6 – + 6
"BASS Q" : Adjust the Bass quality factor.
Setting values: 1.00 / 1.25 / 1.50 / 2.00
This mode is available only when the Sound coordinate system is
on. (page 35)
NOTE