Filter
Top Products
— 15 —
Recalling your settings of the Crossover network:
Press a preset button (#1-6) for the desired Crossover network
setting.
Storing your settings of the Crossover network:
Press a preset button (#1-6) for at least two seconds.
"PHASE : Adjust the phase for Non-Fading output.
Setting values: NOR (0°) / REV (180°)
Adjust various parameters of the Crossover network.
Press the AUD button repeatedly and switch the display to
“X’OVER CTRL” to enter the Crossover network control mode.
Pressing the button cycles through Audio control mode,
Crossover control mode, and Control mode off.
Selecting mode
Press either the FM or AM button.
Each time the button is pressed, the adjustment mode will
change.
Please refer to the following for the contents of the adjustment
modes.
Adjust each mode
Press the 4/¢ button.
Please refer to the following for the adjusting values.
Press the AUD button once to end the Crossover network
control mode.
4
3
2
1
Digital Crossover Network
"LPF NF" : Adjust the frequency of the Low-pass filter for Non-
Fading output.
Setting values: 50 Hz / 80 Hz / 120 Hz / THROU
"HPF F" : Adjust the frequency of the High-pass filter for front
output.
Setting values: THROU / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz /
150Hz / 180Hz / 220Hz
You can separately set the high-pass filter for front and rear
output,including preouts. The high-pass filter does not affect the
non-fading preout.
NOTE
"HPF R" : Adjust the frequency of the High-pass filter for rear
output.
Setting values: THROU / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz /
150Hz / 180Hz / 220Hz
You can separately set the high-pass filter for front and rear
output, including preouts. The high-pass filter does not affect the
non-fading preout.
NOTE