Filter
Top Products
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
74
KEYPAD DIRECT ENTRY
You can select the desired operating frequency, memory
channel, or tone frequency by entering numbers directly
from the MC-53DM microphone. To use this function,
assign the Enter function to any Programmable Function
key first {page 72}.
■ Operating Frequency Entry
1 Select the desired band.
2 Press [VFO] to select VFO mode.
3 Press the Mic key re-programmed with Enter.
• The display for Direct Frequency Entry appears.
4 Use the Mic keypad to enter the desired frequency.
• Enter the digits in order from the most significant down
to the least significant.
• When the current step size is 5 kHz, 10 kHz, 15 kHz,
20 kHz, 25 kHz, or 50 kHz, enter numeric values down
to the 1 kHz digit. Enter either 0 or 5 for the 1 kHz
digit.
• On versions with receiver coverage wider than 10
MHz, enter from the 10 MHz digit. For other versions,
begin entering from the 1 MHz digit.
00
12.5
25
37.5
37.5
0
1
2
3
4
5
6
7
8
9
50
62.5
75
87.5
87.5
Frequency
(kHz)
10 kHz Key
Frequency
(kHz)
10 kHz Key
Note:
◆
If you press any key other than [0] ~ [9] or [Enter], or if you do
not make the next entry within 10 seconds, direct entry is
canceled and the VFO mode is restored.
◆
If you press Mic [Enter] while entering a frequency, the new data
is accepted for the digits entered and the previous data remains
unchanged for the digits not yet entered.
◆
Except for the 1 kHz digit, entering a digit that is outside the
allowable range causes the nearest digit within range to be
displayed. For the 1 kHz digit, pressing [0] ~ [4] selects "0" and
pressing [5] ~ [9] selects "5".
◆
When the current step size is 6.25 kHz, 12.5 kHz, or 25 kHz,
entering the 10 kHz digit completes frequency setting. The
10 kHz and subsequent digits are set according to which key is
pressed for the 10 kHz digit as shown in the table below.